MIMAKI UJF-3042HG Especificaciones descargar pdf (Pagina 40)

2-4

Setting the media

Open the table front cover.

Set media along the L-shaped mark (drawing

origin) on the right corner of the table.

• To change the drawing origin, see the following page.

( P.3-2 "Changing origin")

• To use tools, set into the shaves (8.0 mm-deep) on the corners

of the table.

Close the table front cover, and press the key.

• The origin is detected. Please wait until the operation is finished.

Adjust the table to an appropriate height for drawing by pressing the

TABLE keys, and press the key.

• When the media thickness is 100mm and less, media inflation is required so that the media thickness

may be 100mm.

• When the media thickness is 100mm and more, it is necessary to align it with the drawing height with

the table up/ down key.

• The peripheral parts of the media could roll up due to heat. Fix the media supplementarily using

adhesive tapes, etc.

• Adjust the height of the table with the media to 150 mm or less.

ENTER

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 155 156

Sin comentarios

MIMAKI UJF-3042HG Especificaciones Pagina 40